Rock-Slide Engineering TJ REAR BUMPER - Manual (Page 3)

INSTALLATION INSTRUCTION RSEI 105
*If any parts listed are missing or damaged please call Rock-Slide Engineering @
435-752-4580 prior to installation
TJ REAR BUMPER INSTALLATION
1. Remove stock bumper and spare tire carrier. Set aside all of the hardware.
a. The tire carrier (8) bolts will be REUSED
2. Position the R-SE bumper into its desired location on the frame cross member. Line
up the bumper holes to the factory mounting holes on each side of the cross
member. (see arrows above for factory mounting holes)
a. Mark the center holes on the bumper on the frame cross member in order to
drill holes for nutserts
b. Set the bumper down
3. Install the nutserts
a. Carefully drill a 7/32’’ pilot hole into the center of the 2 marked points on
frame cross member
b. From the center of the pilot hole, step up the hole size using a ½” bit to
create a finish hole that will be used to install the nutserts
Bumper center holes