Hornady Lock-N-Load Rifle Bullet Feeder - Manual (Page 11)

Die Adjustment
Preparation
As with all dies, disassemble the die and clean thoroughly.
Reassemble according to the illustration. Do not attach the
Feeder Body (63).
Set the distance between the Crimp Adjust Screw (46) and
the Crimp Adjust Lock Ring (47) to 0.10" (about 2 turns
back). The Crimp Adjust Lock Ring should have firm tension
on the O-Ring (48) against the Die Body (51).
Loosen the Seat Adjust Lock Ring (44) and back out the Seat
Adjust Screw (42) about one inch to ensure that the bullets
won’t be seated too deep.
17
18
17
18
Crimp Adjust
Seat Adjust
Crimp Adjust
Lock Ring
Seat Adjust
Lock Ring
.10"
2 turns
back
1.0"
- 11 -