Hornady Lock-N-Load Pistol Bullet Feeder - Manual (Page 8)

Place a ¼" Flat Washer (31) over the end of each of the two
Bolts just previously place through the Bullet Feed Hopper
and Square Tubing Mounting Bracket.
Place a ¼-20 Hex Nut (14) onto the two ¼-20 X 2 SHCS Bolts
and tighten snug.
Bullet Feed Hopper Set Up
Loosen ¼-20 Thumb Screw (10).
Loosen Lock Nut (7) on the Adjustment Screw (6).
7
8
9
Tighten Hex Nut
Lock Nut
Thumb Screw
7
8
9
Adjustment
Screw
ASSEMBL
Y
- 8 - ASSEMBLY: PISTOL BULLET FEEDER