Drop funnel bullet wiper (top wiper) – Hornady Lock-N-Load Pistol Bullet Feeder User Manual

Page 10

Insert the Drop Funnel (5) into Tube Spring Clamp (3). You will
want the front edge (outside edge) of the Drop Funnel as close
to the Bullet Feed Wheel Pistol without touching the Bullet Feed
Wheel Pistol.
Tighten the Knurled Thumb Screw (2) on the side of the Tube
Spring Clamp. Only snug this screw,

DO NOT over tighten this

screw.

Install the wipers as shown in with one Wing Nut installed on
the outside of the Bullet Feed Hopper) on the Wiper Screw.
Place one bullet facing the center of the Bullet Feed Wheel
Pistol base first. Next to it, place a bullet facing nose first
to the center of Bullet Feed Wheel Pistol. The bullet that is
facing nose first, push the nose down a little so the base
is sticking up.
Adjust the second Wiper Spring and Wiper Screw to just
miss the nose of the first bullet but kick the base of the
second bullet.
Tighten down the two Wing Nuts and the Thumb Screw.

Select the correct size of Drop Funnel for your application.
9MM/38/.357 ...........(375 I.D.) ............Item No. 399216
40 S&W/10 MM ........(406 I.D.) ............Item No. 399215
.44/.451/.452 ............(530 I.D.) ............Item No. 399214

Drop Funnel

Bullet Wiper (Top Wiper)

Wiper Screw

Thumb Screw

Wiper Spring

Drop Funnel

Wing Nuts

Tube Spring

Clamp

Bullet Feed

Wheel Pistol

Knurled Thumb

Screw

ASSEMBL

- 10 -

ASSEMBLY: PISTOL BULLET FEEDER