Hornady Lock-N-Load Pistol Bullet Feeder - Manual (Page 6)

Mounting the Bullet Feeder
to the Bench
Refer to Appendix B for the template.
Place the template on the table in the location you would
like to mount the press and Lock-N-Load
® AP ™ Pistol Bullet
Feeder. Drill ¼" holes for the placement of the Square Tubing
Mounting Bracket.
Use ¼" bolts with ¼" Flat Washers (not provided, due to
different thicknesses of tables) on top of the Square Tubing
Mounting Bracket and also one on the bottom of the bench.
Once the Support Tube-Bottom (36) is securely attached to
the bench top, line up the Support Tube-Top on the front of
the tube, oriented as shown in the exploded view on page 27.
Slide a ¼-20x2.5 Carriage Bolt (39) through one of the square
holes in the top tube and through the slot in the bottom tube.
Place a ¼” Flat Washer (31) over the bolt and thread on a
¼-20 Wing Nut (25). Repeat with another bolt, washer, and
nut through the other square hole. The height of this tube
may need to be adjusted at a later time in order to allow
bullets to slide freely down the Drop Tube (33).
1
2
3
1
2
ASSEMBL
Y
- 6 - ASSEMBLY: PISTOL BULLET FEEDER