SkyTrak 8042 Parts Manual - Manual (Page 35)

BOOM
31200732 8042/10042/10054 2-13
Figure 2-4 Third Boom Section
Item Part Number Qty. Description Rev.
1 7117113 1 THIRD BOOM SECTION, (8042 & 10042)
2 7082311 16 WEAR PAD INSERT
3 7111572 2 WEAR PAD
4 7096882 2 WEAR PAD SPACER, 0.62
5 7082362 AR SHIM, WEAR PAD, 0.13
6 7082342 AR SHIM, WEAR PAD, 0.07
7 8307005 16 LOCKWASHER, 3/8
8 8303679 6 HEX HD CAPSCREW, 3/8-16X1-3/4, (torque to 31 lb-ft/42 Nm)
9 8526007 AR LOCTITE ® 242 ™ , (apply to items 8, 12 & 13)
10 7096702 1 WEAR PAD SPACER, 1/2
11 7079572 5 WEAR PAD
12 8303675 2 HEX HD CAPSCREW, 3/8-16X1-1/4, (torque to 31 lb-ft/42 Nm)
13 8303681 8 HEX HD CAPSCREW, 3/8-16X3/4, (torque to 31 lb-ft/42 Nm)
14 8307204 8 FLAT WASHER, 3/8
N1 Note Ref
USE LOCTITE
®
242
™
(0100011) ON ALL BOLT THREADS AND JAM NUTS.
N2 Note Ref COAT STATIC, NON-ROTATING PIN BORES WITH MOLY-PASTE (3020040).
DO NOT COAT THE PIN OR ANY ROTATING PARTS.
N3 Note Ref COAT ALL BUSHINGS, SHEAVES AND ROTATING PIN BORES WITH
MYSTIK TETRIMOLY GREASE (14404793) PRIOR TO INSTALLATION OF
THE PIN.
N4 Note Ref WEAR PAD SHIMMING:
a. WHENEVER A SHIM IS USED WITH A PAD, A SPACER WITH HOLES
MUST BE INSERTED BETWEEN PAD AND SHIM.
b. THE WEAR PAD OR WEAR PAD INSERT MUST NOT SIT DIRECTLY ON
THE SLOTTED SURFACE OF SHIMS.
c. ADD WEAR PAD SHIMS AND SPACERS AS RQUIRED TO SHIM BOOM
TO MAINTAIN A TOTAL MINIMUM GAP OF 0.070 to 0.130 IN (1.8 TO 3.3
MM) IN BOTH HORIZONTAL AND VERTICAL DIRECTIONS.
d. WEAR PAD BOLTS REQUIRE ONE HARDENED WASHER. HOWEVER,
UP TO (2) HARDENED WASHERS MAY BE USED EXCEPT WHERE
NOTED OTHERWISE. UNDER NO CIRCUMSTANCES SHOULD MORE
THAN (2) HARDENED WASHERS EVER BE USED.
e. THE LENGTH OF PAD BOLTS DEPENDS ON THE NUMBER OF SHIMS
USED. THE BOLT CANNOT EXTEND PAST CHAMFER ON WEAR PAD.
N5 Note Ref ADD MYSTIK TETRIMOLY GREASE (14404793) TO ALL WEAR PADS AND
ALL WEAR PAD SLIDE PATHWAYS. IF APPLICABLE, THIS INCLUDES ALL
PAD GREASE FITTINGS AT THE REAR OF BOOM.