Brother XE5427-001 - Manual (Page 79)

Attaching the Embroidery Foot 77
3
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
e
While pressing in the lever with your finger, fit
the embroidery foot bar over the needle clamp
screw to attach the embroidery foot to the
presser foot bar.
a Presser foot bar
b Needle clamp screw
c Embroidery foot bar
f
Secure the embroidery foot with the presser
foot holder screw.
Set the embroidery foot perpendicular.
a Presser foot holder screw
g
Firmly tighten the presser foot holder screw.
Turn the screwdriver toward the front.
a Screwdriver
CAUTION
a
c
b
a
a
● Do not hit the needle with your finger or
the embroidery foot when attaching it.
The needle may break or cause injury.
● Be sure to tighten the screw with the
included screwdriver. If the screw is
loose, the needle may hit the embroidery
foot and break or bend.
● Before embroidering, always turn the
handwheel toward you (counterclockwise)
slowly to make sure that the needle does
not hit the embroidery foot. The needle
may break or bend.
appendix1 Page 77 Monday, August 18, 2008 8:08 PM