Fast & Fluid TM300 - Manual (Page 6)

Safety Instructions
The manufacturer accepts no liability if the instructions below are not followed:
1. If a machine has been damaged (during transport, for example), do not attempt to set it in operation.
When in doubt, fi rst contact either your supplier or the F&FM service department.
2. The equipment should be positioned and connected up in strict accordance with the installation
instructions.
3. All local safety regulations and ordinances should be observed.
4. The machine may be connected only to a 230V/16A/50Hz or 110V/25A/60HZ earthed wall socket in-
stalled in accordance with the regulations.
5. Users should see to it that the machine is kept in good condition. Defective components should be
replaced.
6. In order to prevent physical injury, the doors should be closed and the paneling fi tted during normal
use.
7. All service activities (other than routine maintenance and adjustments) may only be carried out by-
qualifi ed technicians. See to it that the mains lead is always kept unplugged while repairs are being
carried out.
8. Because of the design of the valve, a nozzle drill may never be used. Cleaning is done by running the-
cleaning program.
Attention! Before installing the equipment and setting it in operation, please read the
instructions for use carefully. This is safer for yourself and prevents unnecessary
damage to the machine.
Attention! Switching off the dispenser with the emergency stop will also
stop colorant agitation.
Specifi c warnings and tips
Attention! MOVING PARTS CAN CAUSE INJURY. Always turn off power
(e.g. by pressing emergency stop) before accessing moving parts.
6