Fast & Fluid SK350 - Manual (Page 3)

Fast & Fluid Management – SK350
V 2.0 page 3
Introduction & warranty
Introduction
By selecting a Fast & Fluid Management shaker you have opted for a product which is the
result of intensive research. Top-quality components, craftsmanship and a modern ergonomic
design all serve to guarantee a long service life and a high degree of user friendliness.
Warranty
In these warranty conditions, 'F&FM' is understood to mean Fast & Fluid Management. The
warranty conditions incorporated into F&FM's general conditions of sale are summarized as
follows (for free general conditions you can contact F&FM).
F&FM guarantees the proper operation of any goods which it supplies, for a period of one year,
except where a breakdown is the result of normal wear and tear. The cost of any inspection
activities carried out by F&FM, with the aim of establishing whether or not a breakdown is
covered by the warranty will be reimbursed by the other party if it transpires that the
breakdown is not covered by the warranty. If it transpires that a breakdown is covered by the
warranty then F&FM will supply identical or equivalent goods under the conditions referred to
in point 6 of the general conditions of sale. The warranty obligation described in this article
only applies if the goods supplied by F&FM have been used in accordance with the manual.
Time spent on warranty-related activities, including travel time, travel costs and
accommodation costs, are charged at current rates.
In contrast to the above, F&FM will not be held to any warranty obligation if:
1.
Repairs have been carried out, or attempted, by the other party or a third party, unless
F&FM had previously declined to repair the goods for a fair price;
2.
F&FM demonstrates that the defect did not emerge during testing;
3.
The other party fails to inform F&FM of the defect immediately, if possible either by letter
and/or by fax, providing full, accurate details and/or has failed to comply fully with F&FM's
instructions;
4.
The other party has failed to use or treat the goods properly or in accordance with F&FM's
instructions;
5.
The damage has been caused by incidents, beyond F&FM's supervision, which have
occurred either during transport or installation.
CE certification
The machine is CE certified. It means that the machine complies with the essential
requirements concerning safety and hygiene. The directives that have been taken into
consideration in the design are available on www.fast-fluid.com.