Fast & Fluid SK350 - Manual (Page 15)

Fast & Fluid Management – SK350
V 2.0 page 15
Machine starts shaking
before the container has
been clamped
Too much spindle resistance Clean the spindles and lubricate
Clamping plate force incorrectly
set
Call service
Clamping plate will not go
up after mixing Clamping plate is jammed call service
Clamping motor is defective Call service
Cable of the clamping motor is
defective Call service
Main board is defective Call service
Container unclamps while
mixing
Container(s) not centered Replace container(s) in
gravitational centre.
Service and Support
If necessary, you can get in touch with your supplier or the local service department, or
contact the manufacturer directly. If you contact the manufacturer, make sure that you have
the model number and serial number to hand. They can be found on the nameplate on the
machine.
For more information please visit our website www.fast-fluid.com
Fuses
Replace fuse at rear of SK350.
>
Remove mains connector
and pull fuse tray
outwards.
The inner fuse is the
(damaged) one to replace, the
outer is the spare to replace it
with.
Dispose of the burnt fuse and
in time, remember to get a new
spare, type 5x20/T10A (slow).
If problem persists, check
mains for power surges.