Fast & Fluid Hercules Digital - Manual (Page 20)

FAST & FLUID MANAGEMENT srl
A Unit of Idex Corporation
1155383H-it,en,es,fr,de - 12/06/2008 20
13. ADJUSTING TRANSMISSION BELTS
Remove back panel from the machine.
Check belt tension, which should bend 5 ÷ 10 mm while pressed with fingers in its side.
To correct the tension, do/undo the bolt (13 mm) as shown in the picture
Check the belt by rotating the main pulley. The belt should not be worn.
Put the back panel in its original position.
INVERTER BOARD
LOGIC BOARD
POWER BOARD + RELE’