Fitting procedure – ARB 5620010 User Manual

Page 9

FITTING PROCEDURE

Passenger side Drivers side
(with trimmed clip)

13. If parking sensors are to be fitted, insert them

in the holes with the wiring pointing towards
the outside of the bar as shown.

NOTE: the passenger side sensor clip will
require trimming as shown below.

14. The rear bar can now be fitted.

Carefully slide the rear bar over the chassis,
taking care not to damage the plastic bumper.
This may require 2 people.

15. With the bar sitting on the vehicle, place the

recovery hook on with the large offset to the
bottom, and attach to the front face using
M12 x 50 x 1.25 bolts, 12mm flat washers
and 12mm spring washers.

Do not fully tighten.

16. Take the chassis spacer and place between

the chassis mount and the chassis of the
vehicle. Attach using M12 x 50 x 1.25 bolts,
12mm flat washers and 12mm spring
washers.

Check alignment of bar to vehicle, and then
tighten all bolts to specified torque

One person each side to lift bar into place

Large distance between bolts and
end of plate to the bottom

Last Rev Date: 13/3/07

Page 9 of 10

Fitting instructions# 3786375