ARB 5620010 User Manual

Page 8

Once the bumper has been cut, refit each

corner to the vehicle by clipping it the top and
side and refitting the screw to the underside.
Refit the scrivet on the passenger side.

10. Before fitting the rear bar, the exhaust mount

must be released by pulling the rubber mount
towards the rear of the vehicle and allowing
the exhaust to drop slightly. This allows
access to the bolt holes.

11. The tab found below the door opening in the

centre of the car must be gently bent down to
vertical with a hammer.

12. Before the bar is fitted, the M6 cage nuts

must be fitted to the outside 6 holes only.
Fitting the cage nuts to the centre holes will
be done once the bar is fitted.

Pull rubber towards
rear of vehicle

Push exhaust slightly towards
front of vehicle until it is
released from rubber mount as
shown

3 Cage nuts each side

Last Rev Date: 13/3/07

Page 8 of 10

Fitting instructions# 3786375