ARB 5620010 User Manual

Page 6

Marking the cut lines

Corner section cut line

Images are of the left hand (drivers) side

First measure down 25mm from the rebate

and scribe a line (1) on the curved inner
face.

Then run a line (2) down the corner of the

vertical face and the centre section of the
bar, followed by a line (3) along the bottom
as shown.

Place a ruler between the end points of the
two lines and draw a line (4) as shown.

For the final line (5) join the top of line 2 and
the start of line 1 as shown.

This line can be cut to remove the corner
from the centre section

Square section cut line

Start by measuring 40mm from the edge and
draw a line (A) down using a square.

Then but the ruler into the plastic whilst
resting the top surface of the box section and
mark on each side of the ruler at 20mm

Repeat this process this time placing the
ruler between the two double ribs and
marking each side of the ruler at 35mm out.

Join the first 2 marks with a line (B), and the
second 2 marks with a line (C).

Measure 25mm down
and scribe line 1 here

Line 2

Line 3

Line 4

Line 5

Line C

Line B

Line A

Last Rev Date: 13/3/07

Page 6 of 10

Fitting instructions# 3786375