ARB 5620010 - Manual (Page 7)

FITTING PROCEDURE
On the side of the box section measure a
point 110mm from the end and square a line
(D) down.
Turn the bar over to mark the cut lines
underneath. Place the ruler in the corner of
the box section and mark at 110mm.
Draw a line (E) from this point to the end of
line D
Place the ruler on the surface hard against the
double rib and measure out 70mm
Draw a line (F) from this point to the end of
line A
Finally draw a line (G) joining the end of line F
to the end of line E.
7. The final cut line viewed from underneath
8. The final cut line viewed from above.
The bar can now be cut using a hacksaw, air
hacksaw and/or jigsaw, Taking particular
care around the edge closest to the door as
this will be seen when the bar is fitted.
110mm
Line D
Line F
70mm
Line F
Line E
Line G
Take care when
cutting here
Last Rev Date: 13/3/07 Page 7 of 10 Fitting instructions# 3786375
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd