Fitting procedure – ARB 5620010 User Manual

Page 4

FITTING PROCEDURE

To fit the Rear Bar, the plastic bumper must

be cut. This is done at a later stage.

Removing the plastic bumper from the

vehicle.

There are 4 bolts along the top, 2 underneath
the centre of the bar, 1 screw on the
underside of each end, which must be
retained, and a scrivet located on the
passenger side of the vehicle in the door
jamb which should also be retained.

Also undo the connectors for the parking
sensors located in the lower corner of each
end of the bar.

Once all fasteners have been removed, the

bar can be pulled off the clips on each end by
pressing down on the top edge whilst pulling
the side out and back. Take care during this
operation as the corners of the bar must be
reused.

2 underside bolts

Scrivet

End screw to retain

4 top bolts

Last Rev Date: 13/3/07

Page 4 of 10

Fitting instructions# 3786375