Assembly sequence – ARB 3934020 User Manual

Page 4

Text mode
Original mode

13/06/06

Page 4 of 13

3782863

ASSEMBLY SEQUENCE.

1. Position the lower buffer on the winch

bumper and assemble using the M6 flange
nuts.

1. Insert the side buffers through the holes and

fix using the M6 flange nuts.

NOTE

Sahara bumper buffer has no large top hole.

1. Glue the light surrounds to the bar using a

silicone based rubber adhesive. Run the
bead along the cavity on the rear side of the
part. Position the surround to align the inside
edge with the buffer and concentric to the
light.

2. Wipe off any adhesive on the front face of

the bar. Allow adhesive to cure before
continuing.

3. If fitting optional fog lights, do so at this

stage.

4. If fitting Sahara Bumper go to step 7