ARB 3934020 - Manual (Page 10)

13/06/06 Page 10 of 13 3782863
21. (If not fitting winch)
1. Wrap rubber extrusion around winch cover.
2. Place washers over the winch cover fixing
holes located on the top middle face of the
winch bumper.
3. Place the winch cover on top of the winch
bumper inline with the mount holes.
4. Bolt together using the M6 button head
stainless steel screws and M6 nuts.
22. 1. Fasten the Cap Wing Cover to the bar using
the christmas tree clips, M6 x 20mm bolts,
washers and nyloc nuts.
Three christmas tree clips are used on the
inside holes.
The bolts are for the two end holes.
23.
With winch
Without winch
(If fitting with winch.)
1. Peel off one side of the double sided tape
and adhere to the top rear side of the number
plate. Note: Clean the adhering surfaces
before applying tape with an alcohol solvent.
2. Peel off the other side of the tape and bolt to
the winch bumper with the M6 X 16mm bolts
and M6 flange nuts through the lower holes
of the number plate.
3. Press firmly to the top of the number plate so
the tape can properly adhere.
(If not fitting with winch.)
1. Bolt the number plate through the top holes
using M6 X 16mm bolts and M6 flange nuts.
If desired the double sided tape can be used
down the sides of the number plate.