Fitting procedure – ARB 3462030 User Manual
Page 8
Last Rev Date: 3/4/06
Page 8 of 12
Fitting instructions# 3783194
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
FITTING PROCEDURE
19. Remove lights from cartons and then remove
screws and speed nuts from each light.
These fasteners are not to be reused – new
screws are supplied in the fitting kit.
20. Insert nylon nuts into square holes in light
brackets inside wing area
21. Fit lights using screws supplied in fitting kit,
taking note of RH and LH light bodies, they
are different, marked LH or RH and must be
placed on the correct side of bull bar (drain
holes down).
22. Secure the number plate bracket using M6
bolts, flat washers and flange nuts. Attach the
shorter side to the bullbar and the longer side
to the number plate.
- RD153 (40 pages)
- RD139 (36 pages)
- RD93 (34 pages)
- RD101 (46 pages)
- RD100 (46 pages)
- RD104 (46 pages)
- RD103 (46 pages)
- RD102 (46 pages)
- RD105 (46 pages)
- RD125 (42 pages)
- RD117 (44 pages)
- RD116 (44 pages)
- RD113 (42 pages)
- RD147 (44 pages)
- RD109 (42 pages)
- RD158 (38 pages)
- RD158 (44 pages)
- RD166 (42 pages)
- RD168 (44 pages)
- RD115 (44 pages)
- RD80 (44 pages)
- RD82 (40 pages)
- RD81 (40 pages)
- RD119 (40 pages)
- RD99 (40 pages)
- RD83 (44 pages)
- RD84 (44 pages)
- RD132 (40 pages)
- RD05 (38 pages)
- RD12 (44 pages)
- RD114 (36 pages)
- RD40 (38 pages)
- RD197 (42 pages)
- RD94 (40 pages)
- RD44 (46 pages)
- RD85 (42 pages)
- RD127 (40 pages)
- RD128 (40 pages)
- RD138 (40 pages)
- RD20 (44 pages)
- RD32 (44 pages)
- RD110 (42 pages)
- RD106 (48 pages)
- RD107 (48 pages)
- RD136 (42 pages)