Fitting procedure – ARB 3462030 User Manual
Page 4
Last Rev Date: 3/4/06
Page 4 of 12
Fitting instructions# 3783194
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
FITTING PROCEDURE
1.
Remove the parker/indicator lights
2.
Undo and remove the grille. Undo the four
screws across the top and three clips into
lower plastic trim (locations as shown).
Depress clips to release tabs on grille (as
shown at Step 3). One clip is located in the
lower centre of the grille and two are located
outboard below the indicator light positions
located as shown.
3.
Showing clip detail, note that you may need a
large flat blade screwdriver to reach the
middle clip while reaching behind grille.
4.
Remove plastic trim, this is secured by five
screws located as shown.
Clip locations
Screw
locations
Depress this
clip to release
grille tab.
- RD153 (40 pages)
- RD139 (36 pages)
- RD93 (34 pages)
- RD101 (46 pages)
- RD100 (46 pages)
- RD104 (46 pages)
- RD103 (46 pages)
- RD102 (46 pages)
- RD105 (46 pages)
- RD125 (42 pages)
- RD117 (44 pages)
- RD116 (44 pages)
- RD113 (42 pages)
- RD147 (44 pages)
- RD109 (42 pages)
- RD158 (38 pages)
- RD158 (44 pages)
- RD166 (42 pages)
- RD168 (44 pages)
- RD115 (44 pages)
- RD80 (44 pages)
- RD82 (40 pages)
- RD81 (40 pages)
- RD119 (40 pages)
- RD99 (40 pages)
- RD83 (44 pages)
- RD84 (44 pages)
- RD132 (40 pages)
- RD05 (38 pages)
- RD12 (44 pages)
- RD114 (36 pages)
- RD40 (38 pages)
- RD197 (42 pages)
- RD94 (40 pages)
- RD44 (46 pages)
- RD85 (42 pages)
- RD127 (40 pages)
- RD128 (40 pages)
- RD138 (40 pages)
- RD20 (44 pages)
- RD32 (44 pages)
- RD110 (42 pages)
- RD106 (48 pages)
- RD107 (48 pages)
- RD136 (42 pages)