ARB 3462030 - Manual (Page 6)

Last Rev Date: 3/4/06 Page 6 of 12 Fitting instructions# 3783194
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
FITTING PROCEDURE
10. Slide mount brackets into chassis ends
oriented as shown with large flanges
outboard.
11. Position the nut plates with three M12 nuts
fitted into chassis brackets, so that all holes
line up with existing bumper mount holes in
outboard side of chassis. Fit three M12 x 40
bolt and washer sets per side. Do up finger
tight only
NOTE: THIS STEP FOR 1500 CHASSIS ONLY
12. Insert the nut plate with two nuts inside the
bracket and chassis to accept two M12 x 40
bolt sets in the tow hook position. Do up
finger tight only.
13. Nip up all bolts, check that the brackets are
parallel to each other and the front edge of
bracket flange is vertical, if not adjust and
retighten.