ARB 3462010 - Manual (Page 36)

27/9/05 Page 9 of 13 3783171
3. IF FITTING WINCH
3.1 As supplied the winch handle should be in
the position as shown.
Remove cable retaining band and position
cable loop so it will go through roller
fairlead when it is placed in bull bar.
3.2 Fit control box to pan:
• For 9500-12000lb winches, use
universal control box bracket supplied,
attaching to rear of control box mount
studs.
• Slide bracket flange under pan and
align with mount slots.
• Fasten in position with 2 x M10 cap
screws, black washers and flange nuts.
• For 15000lb winches, use Warn
supplied control box bracket, attaching
to rear of control box mount studs.
• Slide bracket flange under pan and
align with mount slots.
• Fasten in position with 2 x M10 cap
screws, black washers and flange nuts.