ARB RD166 - Manual (Page 22)

3 Installing the Air Locker
20
3.7 Reinstalling the Bearing Caps
F Install the bearing caps oriented as they were marked before they
were removed, and tighten the bearing cap bolts. It is not
necessary to torque them down at this time.
F Check that some clearance exists between the bearing cap and the
seal housing tube. If not, the bearing cap should be removed and
the tube re-­bent for adequate clearance.
F Tighten all bearing cap bolts with a torque wrench to the torque
VSHFLILHGLQ\RXUYHKLFOHPDQXIDFWXUHU¶VVHUYLFHPDQXDO