Gradall 534D-6T Parts Manual - Manual (Page 39)

3-3
BOOM
Third Boom Section
534D-6 Starting Serial No. 0588001
534 D6-TURBO Starting Serial No. 0588008
Original Issue 12-97
Revised 7-12-02
Item Part No. Qty. Description Of Part
10 8820-1532 4 HEX HD CAPSCREW, 3/8-24x3/4,
GR5, (torque to 32-37 ft.lbs.)
8820-1534 AR HEX HD CAPSCREW, 3/8-24x1, GR5,
(torque to 32-37 ft.lbs.)
11 8856-1109 8 FLATWASHER, 3/8
12 9103-3186 2 BEARING PAD
13 9103-1236 2 SPACER
14 9020-5870 AR SHIM
15 8820-1535 4 HEX HD CAPSCREW, 3/8-24x1-1/4,
GR5, (torque to 32-37 ft.lbs.)
16 9112-3019 2 BEARING PAD
17 8820-1065 1 HEX HD CAPSCREW, 1/2-13x1, GR5
Item Part No. Qty. Description Of Part
1 9112-6013 1 BOOM, THIRD SECTION
2 9114-6052 1 PIN WELDMENT
3 8855-1013 1 LOCKWASHER, 1/2"
4 8362-1283 1 WASHER
5 8820-1565 4 HEX HD CAPSCREW, 1/2-20x1-1/4,
GR5, (torque to 68-78 ft.lbs.)
8820-1566 AR HEX HD CAPSCREW, 1/2-20x1-1/2,
GR5, (torque to 68-78 ft.lbs.)
6 9002-7471 4 HARDENED FLATWASHER, 1/2
7 9108-3297 2 BEARING PAD
8 9108-1447 2 SPACER
9 9112-1081 AR SHIM
1). Add bearing pad shims & spacers as required to shim boom to within 1/16"
of a tight fit. Amounts of shims can vary at each shim point. When a shim is
used with a pad, a spacer must be inserted between pad & shim. No pads shall
sit directly on slotted surface of shims.
2). The length of pad bolts depend on the amount of shims used. Bolt cannot
extend past chamfer on bearing.
NOTE:
TT * Added note to illustration.
NOTE: ALL 534D-6 AND 534D-6 TURBO
MACHINES WITH THE 42’ BOOM
OPTION MUST SEE PAGE 13-14
FOR DETAILS.