Hale SMR-U User Manual

Preliminary, Smr-u stainless steel rear mount pump, Part 1: maintenance instructions

Table of contents

Document Outline

MAINTENANCE INSTRUCTIONS
+ WORKSHOP MANUALforWS - Single Pressure Pump
RECOMMENDED SPARES
- - - - REAR WEAR RING
  - INSTALLATION
    - MAINTENANCE
It is the responsibility of the user to ensure that the equipment is maintained in a safe operational condition, as per regulation 5 in the Provision and Use of Work Equipment Regulations 1998.
- - PROTECTION AGAINST FROST
    - - Section 1
        To Remove
        Section 2
        WEARING RING MAINTENANCE
        To Refit
        SECTION 3
        LOW PRESSURE IMPELLER AND REAR WEAR RING
        To Remove
        Maintenance
        Fig 3-1Checking the wearing diameters of the low pressure impeller
        To Refit
        Rear Wear Ring
    - Pump Type
      - To Refit
Re-assembly of the seal is completed as described below. Please note: Mechanical Seals are precision-engineered devices and extreme care must be taken to ensure that no damage occurs to the lapped faces.
- - - - Section 5
LOW PRESSURE MANIFOLD AND FILTER HOUSING
- - - - To Remove
        Reassembly
        Filter Housing
        Section 7
        To Remove End Covers
        Reassembly
Supplement for World Series Pump Maintenance – WT
SMR-ACManual, 029-0020-78-0 - Rev-B.pdf