Philips MLINK - Manual (Page 14)

14
SLEEP
TV/VCR ON/OFF POSITION FREEZE
SWAP SOURCE
UP
SOUND PICTURE
MENU
CH
MUTE
PIP CH
SOURCE CC CLOCK
ITR/REC HOME HOME PERSONAL
VIDEO MOVIES
INCR. SURR.
PROGRAM LIST
SURF
OPEN/CLOSE
POWER
DN
A/CH
PIP
M LINK
VOL
STATUS/EXIT
TUNER A/B
OK
1
6
2
4
5
4
TV
VCR
POWER/STBY
MENU
SAP
SPEED
SLOW
CHI CH3
VCR-AV3
3
VCR
POWER/STBY
MENU
SAP
SPEED
SLOW
VCR-AV3
VCR
POWER/STBY
MENU
SAP
SPEED
SLOW
VCR-AV3
POWER ON
4
5
T
ESTING
L
EARNED
R
EMOTE
C
ONTROL
F
UNCTIONS
A fter the remote control functions
of accessory devices have been
learned by M-Link ™ , you can test
whether the functions shown on the
screen are being correctly carried
out by the accessory device.
Press the M LINK button on
your TV remote control to enter the
M-Link
™ menu.
Press the CURSOR RIGHT
button repeatedly until the name of
the device whose functions you
want to test (VCR or DVD, for
example) is highlighted.
Press the CURSOR DOWN or
CURSOR UP button repeatedly
until the name of the function you
want to test is highlighted.
Press the CURSOR LEFT or
CURSOR RIGHT button to acti-
vate the highlighted function.
NOTE: If the device did not
respond to the command to perform
the function in step 4, go back to
either the section on “Setting Up a
Philips Device” or “Setting Up a
New or Multibrand Device” and
perform the steps again.
If the device performed the
POWER/STBY function, press the
CURSOR DOWN button to high-
light other functions (MENU,
SPEED, SLOW, etc.). Then press
the CURSOR RIGHT button to
activate each function and check
whether the device performs the
function.
Press the M LINK button on
your TV’s remote control to remove
the M-Link ™ menu from the screen.
When you are setting up a New
or Multibrand device, you must
ensure that you are pressing the correct
buttons on the device’s remote control to
match with the corresponding function in
the M-Link
™ LEARN menu.
Different codes have sometimes been
used for the same function among Philips
accessory devices. If M-Link
™ will not
operate the functions of a Philips acces-
sory device, you may need to delete the
device from M-Link
™ using the onscreen
menu, and then explore the functions of
the Philips accessory device using its
remote control. Follow the steps under
“Setting up a New or Multibrand
Accessory Device” to have M-Link
™
learn the remote functions.
S MART H ELP