Philips 32RF52S User Manual

Page 50

ollow these simple steps to have your TV
remote search for the code it needs to work

the functions of your accessory device. Please
read through the steps once before performing
them.

NOTE: The Search method works only with
devices equipped with channel display indica-
tors or channel display capability.

Press the POWER button on the
device your are attempting to program
to turn it ON. Slide the TV/VCR/ACC
Swich to the proper position (depend-
ing on the type of accessory device you
have).

Press the (VCR) RECORD • button
and the SOUND button SIMULTA-
NEOUSLY and hold them down.
Besure that the remote is pointing at
the accessory device.The device will
begin to change channels after the
remote identifies the correct code.

When the channels start to change,
release the (VCR) RECORD • button
and SOUND button.

Don’t let the device scan up more
than five channels. If you do, the
remote control may pass up the correct
code, and another two-minute search
cycle will have to be done.

If no channel change happens within two
minutes, repeat steps 1–4. Should a channel
change still not occur, the remote will not
work the desired device.

SING THE

EMOTE WITH

CCESSORY

EVICES

- S

EARCH

Ⅲ

Cable Converter

Satellite Receiver

VCR

Don’t let the device scan up more than five
channels. If you do, the remote may pass up
the right code, and another search cycle will
have to be done.

If no channel change happens within several
minutes, repeat steps 1–4. Should a channel
change still not occur, the remote control
will not work the desired device.

It is recommended that you use Philips
brand external accessory devices with your
Philips television to insure proper remote
control functions. If you are using Philips
brand accessory devices, your remote con-
trol should be ready to use with these
devices.

ELPFUL

INT