Buhler 2425 - Manual (Page 128)

SECTION 2 - OPERATION
2-70
8. Setting the Transmission Output Shaft
Gear Profile
NOTE: Operation not applicable to
tractors equipped with QSM 11 engines.
NOTE: This value is set when the machine
is built. It does not require operator setup,
and should never be changed.
Instructions are provided here only in the
event the value was inadvertently
changed.
A. The upper portion of the monitor will flash
“GEAR” and “SET,” with “SET UP”
displayed. The lower portion of the display
will show 30 or 60 depending on current
programmed selection.
B. The output shaft gear profile is set
depending on the transmission installed
in the tractor:
12 x 4 Quad Shift III - 30
12 x 2 Powershift - 60
C. To place the correct value into the monitor,
use the digit select switch. Move the
switch to “UP” for 60, or “DOWN” for 30.
D. Push the acknowledge/reset button to
enter the value into the monitor’s memory.
The display will now go to “Setting the
Engine Flywheel Ring Gear Profile.” If no
further calibration is needed, turn the
ignition switch to the “OFF” position. If
further calibration is needed in other
areas, select the area to be calibrated with
the rotary select switch and proceed as
detailed for that switch position.
Figure 2-102