Philips VRX463AT99 - Manual (Page 9)

Hookups With a Cable Box/DSS Receiver (cont’d) 9
CH3 CH4
RF OUT
ANT.IN
AUDIO
CABLE
BOX
VIDEO
IN OUT IN OUT
R
L IN
OUT
ANTE
NNA
IN
75 ⍀
Playing a Tape
1
Press the VCR/TV button to put the VCR in VCR position (the
VCR light will appear on the display panel).
2
Make sure the Cable Box/DSS Receiver is on the same channel as
the VCR’s CH3/CH4 switch.
3
Use the CHANNEL Up/Down buttons at the TV to set the TV to
the Cable Box output channel (03 or 04).
4
Press the PLAY button to play the tape.
This connection allows you to program an unattended recording of more than one unscram-
bled channel and to watch one channel while recording another. After you connect the VCR,
Cable Box/DSS Receiver, and TV as shown below, the features on this page will be available.
Recording One Channel/Watching Another
1
Put the Cable Box/DSS Receiver on the same channel as the
VCR’s CH3/CH4 switch. Put the TV on the Cable Box output
channel (03 or 04).
With the VCR in VCR position (the VCR light will appear on the
display panel), use the CHANNEL Up/Down buttons at the VCR
to select the channel you want to record. Start the recording.
2
Press the VCR/TV button once to put the VCR in TV position.
(The VCR light will disappear.)
3
Use the CHANNEL Up/Down buttons on the TV to set the TV to
the Cable Box/DSS Receiver output channel (03 or 04).
4
Use the CHANNEL Up/Down buttons on the Cable Box/DSS
Receiver to select the channel you want to watch.
• You cannot record scrambled chan-
nels with this connection.
• This connection may not work with
your cable system. You may have to
use the connection shown on page
eight.
• To return to the channel being
recorded, use the CHANNEL
Up/Down buttons at the Cable Box
to set the Cable Box to the same
channel as the CH3/CH4 switch.
Then, press the VCR/TV button to
put the VCR in VCR position.
Helpful Hints
1. Connect a Cable
signal to the VCR’s
ANT(enna) IN Jack.
3. Use a second RF coaxial cable to con-
nect the OUT Jack on the Cable Box/DSS
Receiver to the TV’s ANTENNA IN Jack.
2. Use an RF coaxial cable
(supplied) to connect the
RF OUT Jack on the VCR
to the IN Jack on the
Cable Box/DSS Receiver.
ANTENNA IN Jack
(on back of TV)