Philips VRX463AT99 User Manual

Page 46

POWER

CBL/DSS

VCR

EJECT

MUTE

JOG/SHUTTLE

EXIT/STATUS

CLEAR

VCR PLUS+/ENTER

F.ADV

PAUSE/STILL

100

GO-TO

MEMO

INDEX

VAR.

SLOW

REMOTE LOCATOR

SKIP

VCR/TV

SPEED

SLOW TRACKING

STOP

REW

PLAY

VOL

CHANNEL

/OTR

REC

• If your DSS Receiver does not

respond to the code in steps 9 - 10,
the Controller will not change chan-
nels at the DSS Receiver during a
timer recording. In this case, you
must select the channel to be
recorded at the DSS Receiver before
a timer recording begins. Enter the
DSS Receiver output channel (03 or
04) at step 5 on page 35. Leave
the DSS Receiver on for the timer
recording. Details are on page eight.

• If more than one code is listed for

your brand of DSS Receiver, try all
of the codes at steps 9 - 10 before
you determine the Controller will not
change the VCR channels.

Helpful Hints

SELECT CODE NUMBER

OF YOUR DSS RECEIVER

TO TEST PUSH MENU

DID DSS RECEIVER
CHANGE TO CHANNEL 205?

1 YES 2 NO

TO END PUSH EXIT

Press the MENU button.

Press the Number 1 button to select YES.
“DSS RECEIVER CONTROL IS ON” will appear for five seconds.
The screen will return to the program you were watching.

A zero will appear in the SELECT OUTPUT CH menu.
Press one Number button (3 or 4) to complete the out-
put channel of your DSS Receiver (channel 03 or 04).

•

Press 0 if you connected the VIDEO/AUDIO OUT Jacks of the
DSS Receiver to the VCR’s VIDEO/AUDIO IN Jacks. A/V will
appear on-screen as the output channel. A/V CONNECT A/V
REAR ONLY will appear.

•

If you make a mistake, press the CLEAR button, then enter the
correct output channel.

Press the MENU button.

SELECT OUTPUT CH
OF YOUR DSS RECEIVER

TO END PUSH EXIT

A four will appear in the menu. Use the Number buttons
to enter the second digit of the two-digit code for your
DSS Receiver. (See the list on page 44.)

Press the MENU button. Wait for the DSS Receiver to
change to channel 205. When it does, go to step 11.

•

If the DSS Receiver does not change to channel 205, press the
Number 2 button to select NO. Repeat steps 9 - 10. If the DSS
Receiver doesn’t change to channel 205, the Controller will not
operate your DSS Receiver. Press the EXIT/STATUS button.

46 Setting the Controller to Operate a DSS Receiver (cont’d)

SELECT OUTPUT CH
OF YOUR DSS RECEIVER

TO CONTINUE PUSH MENU
TO CORRECT PUSH CLEAR
TO END PUSH EXIT