Philips Norelco SHAVER Series 9000 wet and dry electric shaver S9721-84 V-Track Precision Blades Contour Detect Technology SmartClean System PRO Digital User Interface with SmartClean System PRO and Aquatec Wet & Dry - Manual (Page 8)

8
Replacing shaving heads
For maximum shaving performance, we advise you to replace the shaving
heads every two years.
- The appliance is equipped with a replacement reminder which reminds
you to replace the shaving heads. The replacement reminder lights up
white continuously and the arrows flash white. You hear a beep to
indicate you have to replace the shaving heads.
Note: After replacing the shaving heads, you need to reset the shaver by
pressing the on/off button for 7 seconds.
Exclamation mark
Blocked shaving heads
- If the shaving heads are blocked, the exclamation mark lights up orange
continuously. The replacement reminder and the cleaning reminder
flash white alternately and you hear a sound. In this case, the motor
cannot run because the shaving heads are soiled or damaged.
- When this happens, you have to clean the shaving heads or replace them.
Overheating
- If the appliance overheats during charging, the exclamation mark flashes orange.
- When this happens, the shaver automatically switches off. Charging
continues once the appliance is back to the normal temperature.
Charging
Charging takes approx. 1 hour.
A fully charged shaver has a shaving time of up to 50 minutes.
Note: You cannot use the appliance while charging.
Note: When the battery is fully charged, the display shows the actual remaining
battery charge percentage.
Charge the shaver before you use it for the first time and when the display
indicates that the battery is almost empty .
Charging with the adapter
1 Make sure the appliance is switched off.
2 Insert the small plug into the appliance (1) and put the adapter in the
wall socket (2).
ENGLISH
8