Philips Norelco SHAVER Series 9000 wet and dry electric shaver S9721-84 V-Track Precision Blades Contour Detect Technology SmartClean System PRO Digital User Interface with SmartClean System PRO and Aquatec Wet & Dry - Manual (Page 15)

15
, The on/off button and the rinsing symbol both light up continuously.
Note: The rinsing phase takes approx. 10 minutes.
Note: The progress bar shows the progress of the rinsing phase.
, During the drying phase, the drying symbol lights up continuously.
Note: The drying phase takes approx. 4 hours.
Note: The progress bar shows the progress of the drying phase.
, When the cleaning program has been completed, the ready symbol
lights up continuously.
, The battery symbol lights up continuously to indicate that the shaver
is fully charged.
Note: Charging takes approx. 1 hour.
Note: If you press the on/off button of the SmartClean system during the
cleaning program, the program aborts. In this case, the rinsing or drying symbol
stops flashing.
Note: If you remove the adapter from the wall socket during the cleaning
program, the program aborts.
Note: 30 minutes after the cleaning program and charging have been
completed, the SmartClean switches off automatically.
Replacing the cartridge of the SmartClean System
- Replace the cleaning cartridge when the replacement symbol flashes
orange or when you are no longer satisfied with the result.
1 Press the button on the side of the SmartClean system (1) and lift
the top part of the SmartClean system (2).
2 Take the empty cleaning cartridge from the SmartClean system and
pour any remaining cleaning fluid out of the cleaning cartridge.
You can simply pour the cleaning fluid down the sink.
3 Throw away the empty cleaning cartridge.
4 Unpack the new cleaning cartridge and pull the seal off the cartridge.
ENGLISH 15