Philips DVD962SA - Manual (Page 14)

14 Hookups (cont’d)
Connecting to a TV and a Multi-channel Receiver that has 2-channel digital stereo (PCM) or
supports Dolby Digital TM , MPEG2, or Digital Theater System
COAXIAL OPTICAL
DIGITAL AUDIO OUT
PCM/MPEG2/Dolby Digital/DTS
MAINS
FRONT
MULTICHANNEL AUDIO OUT
FRONT
CVBS
VIDEO OUT
AUDIO
OUT
S-VIDEO Y P b /C b P r /C r
SURROUND
SURROUND
L
R
CENTER
SUB WF
L
R
1
2
Y P b /C b P r /C r
PROGRESSIVE SCAN OUT
Back of TV
(example only)
3
1
S-AUDIO IN
COAXIAL DIGITAL
AUDIO IN
Receiver
(example only)
2
VIDEO IN
1
Connect one of the DVD Player’s DIGITAL AUDIO OUT jacks
(COAXIAL or OPTICAL) to the corresponding digital audio in jack
on your Stereo Receiver. You only need one connection, so you will not
use both jacks. Use a digital audio cable (not supplied).
2
Connect one of the yellow CVBS VIDEO OUT jacks of the DVD
Player to the corresponding VIDEO IN jack on your TV. Or, use the
S-VIDEO or Pr/Cr Pb/Cb Y VIDEO OUT jacks. Details are on pages 10 and
11. You only need one video connection.
3
Connect the DVD Player’s power cord to the MAINS jack on the
rear of the DVD Player. Connect the power cords of the DVD
Player and the TV to the power outlet. Turn on the power of the
TV and the DVD Player.
4
Set the TV to the correct Video In channel. These channels often are
near channel 00. See your TV manual. Or, change TV channels until you
see the DVD logo on the TV screen.
Set your Stereo Receiver to the correct Audio In channel or sound
source. Refer to the Stereo’s manual.
5
Set the DVD Player’s digital output. Details are on page 43.
• If your Digital Output setting
does not match your Stereo’s
capabilities, the Stereo may
produce a strong, distorted
sound or no sound at all.
• Six Channel Digital Surround
Sound via digital connection can
only be obtained if your Stereo
has a Digital Multichannel
Decoder.
• You may connect a subwoofer
and speakers to the corre-
sponding MULTICHANNEL
AUDIO OUT jacks on the DVD
Player. Follow the instructions
supplied with the subwoofer
and your Receiver.
• Your Stereo must support
MPEG2, Dolby Digital TM or
Digital Theater System (DTS).
Check the Stereo’s manual.
Helpful Hints