Philips DVD962SA - Manual (Page 12)

12 Hookups (cont’d)
Connecting to a TV Only
TV has a single (CVBS) Video In jack
COAXIAL OPTICAL
DIGITAL AUDIO OUT
PCM/MPEG2/Dolby Digital/DTS
MAINS
FRONT
MULTICHANNEL AUDIO OUT
FRONT
CVBS
VIDEO OUT
AUDIO
OUT
S-VIDEO Y P b /C b P r /C r
SURROUND
SURROUND
L
R
CENTER
SUB WF
L
R
1
2
Y P b /C b P r /C r
PROGRESSIVE SCAN OUT
Back of TV
(example only)
3
2
1
LEFT AUDIO IN
RIGHT AUDIO IN
VIDEO IN
LEFT AUDIO IN RIGHT AUDIO IN
AUDIO IN
1
Connect one of the yellow CVBS VIDEO OUT jacks of the DVD
Player to the corresponding VIDEO IN jack on your TV. Use the
supplied yellow video cable.
2
Connect the supplied red and white audio cables to the red and
white Left and Right AUDIO OUT jacks on the DVD Player.
Connect the other end of the cables to the left/right AUDIO IN
jacks on the TV. Match the cable colors to the jack colors.
3
Connect the DVD Player’s power cord to the MAINS jack on the
rear of the DVD Player. Connect the power cords of the DVD
Player and the TV to the power outlet. Turn on the power of the
TV and the DVD Player.
4
Set the TV to the correct Audio/Video In channel. This channel
may be near channel 00. See your TV owner’s manual for details. Or,
continue to change channels at the TV until you see the DVD Player’s
screen saver on the TV screen.
• There are two CVBS VIDEO
OUT jacks, in case you wish to
connect the DVD Player to
another device in addition to a
TV. You may not need to use
both CVBS VIDEO OUT jacks.
Helpful Hint