New Buck Corporation CDVB200 - Manual (Page 27)

Continued
OPTIONAL REMOTE
OPERATION
Note: All remote control accessories must
be purchased separately (See Accessories
on page 24). Follow instructions included
with the remote control.
Thermostat Control Operation
The thermostat control setting on the
remote control unit can be set to any
comfort level. The burners will turn on
and off automatically to maintain the
comfort level you select. The ideal
comfort setting will vary by household
depending upon the amount of space to
be heated, the output of the central
heating system, etc.
1. After lighting, let pilot flame burn
for about one minute. Turn gas
control knob on the control valve to
“ON” position. Turn variable control
knob anywhere between HI and LO.
2. Position the auto/off/manual switch
located on the right rear of the stove
in the auto position.
NOTE: See instructions provided with
the remote control system you have
received.
NOTICE: You must light the pilot
before using the hand-held remote
c o n t r o l u n i t . S e e L i g h t i n g
Instructions, page 21 & 22.
ROOM AIR BLOWER SYSTEM
OPERATION
To turn on the blower system you must
position the on/off switch located on the
left rear of the stove to the On position.
The blower system has a thermostat
located inside the air channel which
turns on the blower motor after the
burner system has reached the proper
temperature. If you have positioned the
ON/OFF switch to the ON position it
may take sometime before the
thermostat is activated and the blower
begins to blow air.
TYPICAL HAND-HELD REMOTE-
CONTROL
TYPICAL REMOTE-CONTROL RE-
CEIVER
23