New Buck Corporation CDVB200 - Manual (Page 24)

Continued
INSTALLING LOGS
WARNING: Failure to position the
parts in accordance with these
diagrams or failure to use only parts
specifically approved with this burner
system may result in property damage
or personal injury.
WARNING: POSITIONING LOGS IS VERY CRITICAL (SEE FIGURE 39).
LOG PLACEMENT FOR LOG SET
1) Place rear log (flat faced) #1 on rear log support. The log has alignment notches on each corner.
2) Place ember strip (wrapped in cardboard box ) #2 on front log supports. Center from side to side.
3) Next place middle log (with ember burn out) #3 over front burner tube. The two ends are notched out on bottom to ensure
proper fitting over ends of burner.
4) Right top log is a “y” shaped log #4. The round stem lays in the notched out space on the right corner of rear log. There is a
pin on the middle log, and a hole on the flattened end of the top left log. Place hole over pin.
5) Place the end of the #5 log with the hole over the pin on the left side (corner) of the #1 log , and the other end of the #5 log
lays on the flat surface of the left side of the #3 log .
FIGURE 39
2
3
5
4
1
“LOG #2 PLACEMENT”
3
4
5
2
1
WARNING: “Do not operate
appliance with the glass front
removed, cracked or broken.
Replacement of the glass should be
done by a licensed or qualified
service person.”
20