Philips MCD515-37 - Manual (Page 34)

34
English
Radio Reception
Tuning to radio stations
1
Select TUNER source.
➜
“
FM” or “AM” is displayed.
2
Press BAND/DISPLAY (TUNER on the
remote) to select the desired waveband : FM or
AM.
3
Press and hold TUNING 22/33 and then
release it.
➜ The display will show " SEARCH" until a radio
station with sufficient signal strength is found.
4
Repeat step 3 if necessary until you find the
desired station.
●
To tune to a weak station, press TUNING
22/33 briefly and repeatedly until you have
found optimal reception.
Programming radio stations
You can store up to 40 radio stations in the
memory (20 for FM and 20 for AM).
Automatic programming
Press PROGRAM for more than three
seconds to activate programming.
➜ All available stations are programmed.
➜ AUTO is displayed and available stations are
programmed in order of waveband.
Manual programming
1
Tune to your desired station (refer to “Tuning to
radio stations”).
2
Press PROGRAM to activate programming.
➜ PROG flashes on the display, in which X stands
for the programme number.
3
Press PRESET н/л to allocate a number
from 1 to 20 for this station.
4
Press PROGRAM again to confirm the setting.
➜ The frequency of the preset station is shown.
5
Repeat the above four steps to store other
stations.
● You can override a preset station by storing
another frequency in its place.
Note:
– During setting, if no button is pressed within 30
seconds, the system will exit manual programming
automatically.
Tuning to preset radio stations
●
Press PRESET н/л until the desired preset
station is displayed.
VOLUME
INCREDIBLE
SURROUND
PROGRAM
TUNING PRESET
SOURCE DBB DSC
CLOCK SET
BAND
STANDBY-ON
ECO POWER
RECORD DISPLAY
M C D 5 1 5 D V D M I C R O T H E A T R E
iR
OPEN/
PROGRAM MODE ANGLE A-B
pg001-pg042_MCD515-37-Eng 2006.2.27, 16:21 34