Philips MCD515-37 - Manual (Page 21)

21
English
Preparations
IMPORTANT!
– Make sure to complete the
preparation procedures before operating
the system.
Step 1: Inserting batteries into
the remote control
1
Open the battery compartment.
2
Place two batteries (Type R06 or AA) in the
compartment with the correct polarity as
indicated by “+” and “–” symbols.
3
Close the cover.
Using the remote control to operate the
system
1
Point the remote control directly at the remote
sensor (iR) on the front panel.
2
Select the source you wish to
control by pressing one of the
source select buttons on the
remote control (for example
DISC, TUNER).
3
Then select the desired function
(for example 2;,
н, л).
CAUTION!
– Remove batteries if they are
exhausted or will not be used for a long
time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances,
so they should be disposed of properly.
Step 2: Setting the clock
1
Go to Standby mode.
2
Press and hold CLOCK SET on the front
panel.
➜
“
SET CLOCK” is displayed briefly. Then, the
hour digits flash on the display screen.
3
Turn the VOLUME control on the front panel
or press VOL +/- on the remote to set the
hours.
4
Press CLOCK SET again.
➜
The minute digits flash on the display screen.
5
Turn the VOLUME control on the front panel
or press VOL +/- on the remote to set the
minutes.
6
Press CLOCK SET to confirm the clock
setting.
Notes:
– This system only supports 24-hour mode.
– The clock setting will be erased when the system
is disconnected from the power supply.
– The system will exit clock setting mode if no
button is pressed within 30 seconds.
T PRESET
pg001-pg042_MCD515-37-Eng 2006.2.27, 16:21 21