BT 3010 Classic - Manual (Page 14)

Diverse 3010 ~ 4th Edition ~ 28th February ~ 3722
Place the handset on the base.
When charging the battery level
symbol shown on the display flashes.
10
Battery display when inserting
or replacing a battery
When you replace the handset batteries
with ones that have been fully charged,
the battery indicator will not show full
until the next charge cycle has been
completed. Charge the handset until
the batteries register full again. From
then on the display will be correct.
Battery performance
After charging your Diverse 3010
Classic for the first time, subsequent
charging time for the handset batteries
is approximately 4-5 hours. Batteries and
case may become warm during charging.
This is normal.
Note
Under ideal conditions, the handset
batteries should give about 10 hours
talktime or 100 hours standby on a
single charge. However, new NiCad
batteries do not reach their full capacity
until they have been in normal use
for several days.
Please note that the lifespan of NiCad
rechargeable batteries depends on how
heavily they are used. However, over
time, their capacity to recharge will
begin to diminish and they will
eventually need replacing.
Slide battery cover down and lift off.
The battery compartment cover may be
found in the packaging with the batteries.
4 Fit the handset belt clip
Fit the belt clip onto the back of the
handset.
T Ta ab b
S Sllo ott
5 When charging for the
first time, we recommend
that you let the batteries
charge for the full 16
hours before making or
receiving calls
SETTING
UP
Diverse 3010 User Guide 22/3/01 1:33 pm Page 10