Philips TSU500 - Manual (Page 28)

User Manual
28
FAQ
How do I reset the ProntoNEO?
Under normal circumstances, you will never have to reset the ProntoNEO.
However, on rare occasions, if the ProntoNEO’s touch screen freezes or if you
notice unusual behavior, you need to perform a reset to get the ProntoNEO running
again. All customized commands and devices are retained.
1 Slide the battery cover off the back of the ProntoNEO.
You will see the Reset button in the battery compartment.
2 Use an unfolded paperclip or a sharp pencil to carefully press the
Reset button.
The ProntoNEO restarts and an Introduction screen appears. The ProntoNEO
beeps twice to indicate it is ready for use.
How do I revert to the original configuration?
Reverting to the original configuration restores the ProntoNEO’s devices and
commands to its state when you purchased it. This means that all programming is
lost permanently. Normally, you never have to revert the ProntoNEO. See ‘Revert’
on p. 14.
1 Press and hold the Mode button for 3 seconds.
The mode screen appears.
2 Tap the Setup button.
3 Scroll to the third setup page.
4 Tap the Revert button.
A message screen appears to confirm or cancel the revert process.
5 Press OK or Cancel.
Do I have to calibrate the touch screen?
The ProntoNEO’s touch screen is calibrated when it leaves the factory. You only
have to calibrate the LCD touch screen when you upgrade ProntoNEO’s software in
the future.
Reset button
ProNeo 01-08-2001 14:40 Pagina 28