Philips TSU500 - Manual (Page 19)

User Manual
19
Using ProntoNEO
4 Tap Learn on the Mode screen.
ProntoNEO is now in Learn Mode. ‘Learn’ and the label of the selected device
appear at the top of the touch screen.
5 Use, if necessary, the Page Up or Page Down button to go to the next
button you want to learn.
6 Press the soft or hard button you want to learn on the ProntoNEO.
The Learn label changes to Learning, which means ProntoNEO is ready to
receive commands from an existing remote control. The ProntoNEO will wait
for 5 seconds to receive an IR code from another remote control.
Note When a hard button is pressed to learn, there is no on screen feedback to indicate
which button is pressed.
7 Press and hold the button on the existing remote control you want to
learn to the ProntoNEO.
When the ProntoNEO receives an IR code:
• You hear a confirmation beep;
• The label changes from Learning to OK. The Learn sequence has been
successful.
ProNeo 01-08-2001 14:40 Pagina 19