Glen Dimplex Home Appliances Ltd 100 - Manual (Page 29)

Installing Your Cooker
Fitting the plinth (if applicable)
●
Make sure the appliance is raised to a height of 915mm
or above before beginning. If the appliance is below
915mm - you can only fit the plinth cover labelled X.
You can adjust the height using the feet (1) of the
appliance.
If your appliance has a storage drawer at the bottom,
you access the required holes through the base of the
drawer after lifting the mat.
●
Open the appliance doors, and loosen screw A located
on bracket (2). Do not remove this screw entirely.
●
Insert screw B, through slot (3) and screw into the small
hole at the bottom of bracket (2).
Make sure that the plinth cover is flush to the appliance
and tighten screw.
Fitting the splashback (if applicable)
●
Remove the screws from the rear of the hotplate vent.
●
Locate the splashback in position so that all the fixing
holes are in line with the holes in the rear of the hot-
plate vent.
●
Re-fit screw into holes to secure the splashback in place.
B
A
(1)
(2)
(3)
X
Y
Door
Plinth cover
Oven cavity