Glen Dimplex Home Appliances Ltd 100 - Manual (Page 28)

Installing Your Cooker
Commissioning - all appliances
Pressure settings:
G20 Natural Gas @ 20mbar
G30 Butane @ 28-30mbar
G31 Propane @ 37mbar
Hob
Turn on gas supply and check for soundness at the
hotplate injector. Light two burners and check that the
pressure is correct.
Grill
Turn the control knob to the full on position and ignite,
allow the grill to operate for a few minutes.
Oven
Turn the control knob to the full on position and ignite,
allow the oven to operate for a few minutes
Connecting to the electricity supply
Mains ignition models only.
Warning - this appliance must be earthed.
The flexible mains lead is supplied connected to a BS
1363 fused plug.
If this plug does not fit in the socket in your home, it
should be replaced by a suitable plug as outlined below.
As the colours of the wires in the mains lead of the
appliance may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows:
The wire which is green and yellow must be connected to
the terminal marked E (Earth) or coloured green.
The wire which is coloured blue must be connected to the
terminal marked N (Neutral) or coloured black.
The wire which is coloured brown must be connected to
the terminal marked L (Live) or coloured red.
The plug and socket must be accessible after
installation.
Should the mains lead ever require replacing, we recom-
mend that this is carried out by a qualified electrician who
will replace it with a lead of the same size and tempera-
ture rating.
Important: ensure that you route all mains, electrical
cables and flexible tubing well clear of any adjacent heat
source.
E (Earth)
GREEN / YELLOW
L (Live)
BROWN
N (Neutral)
BLUE
Use a 3 amp fuse
in a 13 amp plug.
The wires in the mains lead
are coloured in accordance
with the following code:
Green and Yellow = Earth
Blue = Neutral
Brown = Live