Glen Dimplex Home Appliances Ltd 100 - Manual (Page 19)

Baby oil can be used to
restore stainless steel
finishes - but only use a
few drops. Don’t use
cooking oils as they can
contain salts which will
damage the metal.
Take extra care when
cleaning over symbols
on fascia panels,
excessive cleaning can
lead to the symbols
fading.
Always allow your
appliance to cool
down, and switch off
the electricity before
you clean any part of
it.
Cleaning your Appliance
Painted & Plastic parts
●
Only use a clean cloth wrung out in hot soapy water.
●
Do not use abrasive cleaners, such as “Cif”, wire or nylon
cleaning pads on these parts.
Stainless steel & Aluminium surfaces
●
Only use a clean cloth wrung out in hot soapy water, and
dry with a soft cloth.
●
Stubborn marks can be removed using a stainless steel
cleaner. Supplies can be purchased from the Customer
Care Centre.
●
Sharp objects can mark the surface of stainless steel, but
will become less noticeable with time.
●
Wipe any spillage immediately, taking care to avoid burn-
ing your hands.
●
Some foods are corrosive eg; vinegar, fruit juices and
especially salt - they can mark or damage the metal if
they are left on the surface.
Enamel surfaces & parts
●
Clean with warm, soapy water and a clean cloth.
●
Dry with a soft clean towel or cloth.
●
Do not use steam cleaners.
Glass parts
●
Only use a clean cloth wrung out in hot soapy water, or
a specialist glass cleaner.
●
Rinse away any excess cleaner and dry with a soft cloth.
●
Do not use abrasives or polishes as they will scratch and
damage the glass.
●
The inner door glass panel can be removed for cleaning
but it must be replaced the right way up. If there is any
writing on the glass, you must be able to read it clearly
when the cavity doors are open.
●
Always make sure that the glass is pushed fully into the
Stop position.
●
To remove the glass panel, open the door wide, hold the
top and bottom edges and slide out.
●
Warning: Do not operate the appliance without the glass
panel correctly fitted.
!! !
i
i
Don’t use:
undiluted bleaches,
products containing
chlorides or abrasive
cleaners on aluminium
or stainless steel, they
can damage the
appliance.
i
Glass door panels
For your safety, glass door
panels are made of toughened
glass. This ensures that, in
the unlikely event that a panel
breaks, it does so into small
fragments to minimise the risk
of injury.
Please take care when
handling, using or cleaning all
glass panels, as any damage
to the surfaces or edges may
result in the glass breaking
without warning or apparent
cause at a later date.
Should any glass panel be
damaged, we strongly
recommend that it is replaced
immediately .