BlueAnt Supertooth 2 Bluetooth portable handsfree - Manual (Page 26)

HP IPAQ 6315 / 6365 / 6385
Note: Please make sure you have the latest firmware upgrade for your Phone. Go to the
support section of the relevant site to check you have the latest version. You may need to
register your device to download updates.
For Hp 6365 go to
www.hp.com.au
a. ACTIVATING THE BLUETOOTH
You must activate the Bluetooth feature of your device to establish a Bluetooth connection
between your Pocket PC device and other Bluetooth devices.
1. Tap the Bluetooth icon in the bottom right of your today screen.
2. Tap Turn Bluetooth ON
b. PAIRING TO THE CELLULAR PHONE (not possible while charging)
1. Bring your Phone to within about 20 cm from the Supertooth.
2. The Supertooth II is initially off. Turn it on by flipping up the Swivel Arm to the 55º
position. The Bluetooth Indicator will glow (blue blink).
3. Simultaneously press the Reject Button and the Pick-Up/Hang-Up Button for about 10
seconds. A distinctive tone will be heard and the Bluetooth Indicator LED will change
from blinking blue to alternate blinking red and blue. SuperTooth II is now in Handsfree
Pairing Mode.
4. Tap the Bluetooth icon in the bottom right of your today screen.
5. Tap Bluetooth Manager
6. Tap New.
7. Tap Handsfree/Headset Setup…Tap Next
Your device now searches for Bluetooth devices and displays them in the list.
8. Select
display ‘All Devices’
9. Tap the name of the device, Supertooth, and then tap Next.
10. Enter “0000” as the Device PIN and then tap OK.
11. Tap
Finish.
12. For the question, “Do you want to set this device as the default Handsfree device”, tap
Yes.
13. Tap ok, and then 9 to exit.
The Supertooth is now paired with your Phone. An enabled Bluetooth icon will be seen on
screen indicating that the Supertooth is linked with the Phone..
c. ANSWERING/RECEIVING A CALL
When the phone is receiving a call, two dissimilar ring tones will be heard from the phone and
then from the Supertooth.
1. When answering is done on the Supertooth (that is, pressing Pick-Up/Hang-Up
once), audio will be heard on it.
2. When answering is done on the phone, ongoing call will be heard on the phone not
on the Supertooth). But if you wish to hear and transfer the audio to the
Supertooth, just press the Pick-Up/Hang-Up button once on the Supertooth.
3. To terminate the call, press down the Pick-Up/Hang-Up Button.
26