BlueAnt Supertooth 2 Bluetooth portable handsfree - Manual (Page 16)

BLACKBERRY 7100v / 7100g / 7290 / 7250
Note: Please make sure you have the latest firmware upgrade for your Phone. Go to the
support section of the relevant site to check you have the latest version. You may need to
register your device to download updates.
For Blackberry go to
www.blackberry.com
a. ACTIVATING THE BLUETOOTH
You must activate the Bluetooth feature of your device to establish a Bluetooth connection
between your Pocket PC device and other Bluetooth devices.
1. Using the Jog wheel, scroll to Options, Press the Jog wheel button.
2.
Scroll to Bluetooth, Press Jog. Press Jog again and again to select Enable Bluetooth
3. Press Jog and select Close
b. PAIRING TO THE CELLULAR PHONE (not possible while charging)
1. Bring your Phone to within about 20 cm from the Supertooth.
2. The Supertooth II is initially off. Turn it on by flipping up the Swivel Arm to the 55º
position. The Bluetooth Indicator will glow (blue blink).
3. Simultaneously press the Reject Button and the Pick-Up/Hang-Up Button for about 10
seconds. A distinctive tone will be heard and the Bluetooth Indicator LED will change
from blinking blue to alternate blinking red and blue. SuperTooth II is now in Handsfree
Pairing Mode.
4. Using the Jog wheel, scroll to Options, Press the Jog wheel button.
5. Select Bluetooth
6. Press Jog, Select Add Device
Your device now searches for Bluetooth devices and displays them in the list.
7. Select the name of the device Supertooth, and then press Jog.
8. Enter “0000” as the PassKey and then press Jog.
9. Make sure Supertooth is selected and press Jog. Scroll to Device Properties. Press Jog.
10. Scroll to Trusted, press Jog, select Change Option, scroll to Yes and press Jog.
11. Press Jog again and select Save.
12. Now Press Jog again and select Connect.
13. Tap
ok, and then 9 to exit.
The Supertooth is paired with your Phone. An enabled Bluetooth icon will be seen on screen
indicating that the Supertooth is linked with the Phone..
c. RECONNECTING TO THE SUPERTOOTH
After turning the Supertooth off, or going out of range, to reconnect just press the Pick-
Up/Hang-Up button on the Supertooth Once.
d. ANSWERING/RECEIVING A CALL
When the phone is receiving a call, two dissimilar ring tones will be heard from the phone and
then from the Supertooth.
1. When answering is done on the Supertooth (that is, pressing Pick-Up/Hang-Up
once), audio will be heard on it.
16