Bloomfield 9102A - Manual (Page 11)

9
CLEANING INSTRUCTIONS CLEANING INSTRUCTIONS
PROCEDURE: Clean Coffee Brewer
PRECAUTIONS: Turn POWER SWITCH OFF.
Allow brewer to cool.
FREQUENCY: Daily
TOOLS: Mild Detergent, Clean Soft Cloth or Sponge
Bristle Brush
1. Turn POWER SWITCH OFF.
Allow brewer to cool.
2.
Remove satellite.
3.
Remove and empty brew chamber.
4. Remove spray disk and gasket from spray head
5. Wipe inside of spray head and area around spray head with a
soft clean cloth or sponge moistened with clean water.
6. Wash spray disk in a sink using warm water and a mild
detergent. A bristle brush may be used to clear clogged
spray holes. Rinse spray disks with clean water and allow to
air dry.
7. Wash brew basket in a sink using warm water and a mild
detergent. A bristle brush may be used to clean around the
wire racks and bypass channels. Rinse with clean water and
allow to air dry. Be sure wire rack is properly installed.
8. Remove and drain the drip tray. Rinse in a sink under warm
running water. Allow to air dry, then reinstall on brewer.
9. Wipe exterior of brewer and satellites with a soft clean cloth
or sponge moistened with clean water.
10. Reinstall gasket INSIDE brew head, then reinstall spray
disk.
11. Reinstall brew chamber.
12. Reinstall satellite.
Procedure is complete
CAUTION:
Burn Hazard
Brewing and serving
temperatures of coffee are
extremely hot.
Hot coffee will cause
serious skin burns.
IMPORTANT:
DO NOT use steel wool, sharp
objects, or caustic, abrasive or
chlorinated cleansers to clean
the brewer, brew baskets or
satellites.
DO NOT immerse or submerge
satellites in water.
663
76061 Ow
ner
s
M
a
n
ual for
9102A Single Sate
llite
B
re
w
er