Deregistering cordless handsets, For non-colour lcd model, For colour lcd model – Brother BCL-D20 User Manual
Page 12

Chapter 1
6
h
Enter the registered 4-digit PIN number
of the machine (base unit) (The factory
setting is “0000”.) by pressing the dial
pad on the control panel of the cordless
handset.
Press Menu/OK.
Note
• If you hear three short beeps, the cordless
handset did not register. Try to register the
cordless handset again.
• If you want to install another cordless
handset, repeat steps d through h.
• You can change the PIN number. (See
• You can register any GAP compatible
DECT™ handset to your machine (base
unit). Follow steps a through d, then
refer to your handset documentation to
complete the registration. Functions are
limited to making and receiving external
calls.
i
Press Stop/Exit on the control panel of
the machine (base unit).
Deregistering cordless
handsets
1
You can deregister your cordless handset.
If you are using more than one cordless
handset, deregistration will remove all
handsets registered with the machine (base
unit).
For non-Colour LCD model
1
a
Press Menu, 0, 7 on the control panel of
the machine (base unit).
b
Press Erase.
Press 1 to confirm.
c
Press Stop/Exit.
For Colour LCD model
1
a
Press Menu on the control panel of the
machine (base unit).
b
Press a or b to choose
Initial Setup
.
Press OK.
c
Press a or b to choose
Register Handset
.
Press OK.
d
Press a or b to choose Terminate.
Press OK.
Press 1 to confirm.
e
Press Stop/Exit.