For colour lcd model – Brother BCL-D20 User Manual
Page 11
General Information
5
1
f
Enter the registered 4-digit PIN number
of the machine (base unit) (The factory
setting is “0000”.) by pressing the dial
pad on the control panel of the cordless
handset.
Press Menu/OK.
Note
• If you hear three short beeps, the cordless
handset did not register. Try to register the
cordless handset again.
• If you want to install another cordless
handset, repeat steps b through f.
• You can change the PIN number. (See
• You can register any GAP (Generic
Access Profile) compatible DECT™
handset to your machine (base unit).
Follow steps a and b, then refer to your
handset documentation to complete the
registration. Functions are limited to
making and receiving external calls.
g
Press Stop/Exit on the control panel of
the machine (base unit).
For Colour LCD model
1
a
Press Menu on the control panel of the
machine (base unit).
b
Press a or b to choose
Initial Setup
.
Press OK.
c
Press a or b to choose
Register Handset
.
Press OK.
d
Press a or b to choose Register.
Press OK.
The machine (base unit) searches for
the cordless handset.
e
Press Menu/OK on the cordless
handset.
f
Press a or b to choose Register HS.
Press Menu/OK.
g
Press a or b to choose Base1, Base2,
Base3
or Base4.
Press Menu/OK.
Note
• If you have already registered the handset
to a base unit, make sure you choose a
base unit number that is not being used.
For example, if you register the handset to
an additional base unit and you choose
Base1
, the base unit previously stored in
Base1
will be overwritten and the handset
will no longer be connected to it.
• Your machine (base unit) is already stored
as Base1 on the included handset.