Brother FAX2820 - Manual (Page 76)

8 - 1
8
8
‘
Using the machine as a
copier
You can use your machine as a copier,
making up to 99 copies at a time.
Enter Copy mode
Before making copies, make sure that
(Copy) is illuminated in green. If it is
not, press (Copy) to enter Copy mode.
The default setting is Fax mode. You can
change the number of seconds or minutes
that the machine stays in Copy mode. (See
Setting the Mode Timer (FAX-2820 and
FAX-2920 only) on page 2-3.)
The printable area of your machine begins at
approximately
0.16 in. (4 mm) from both
sides and 0.12 in. (3 mm) from the top or
bottom of the paper.
Note
This printable area shown above is for a
single copy or a 1 in 1 copy using Letter or
Legal size paper. The printable area changes
with the paper size.
Making a single copy
1
Press (Copy) to illuminate it in
green.
2
Load your document.
(See Load document on page 1-7.)
3
Press Start.
Making copies
Copy Ratio
The LCD shows the default copy setting
Quality
No. of Copies
0.16” (4 mm)
0.12” (3 mm)
Unprintable
area